Vinyl roof Bars will need to be trimmed to fit the frame. I put one end in one side and then marked to the edge on the other. These then get trimmed down and the plastic ends drilled and pop riveted on. Remember the bar with the locking screw goes at the front.
Disclaimer: For recreational purposes only, some assembly required. Any resemblance
to real persons,
living or dead is purely intentional and the site admins are not responsible
for direct, indirect,
incidental or consequential ridicule resulting from any defect or failure to
perform. No animals
were harmed in the creation of this forum. Colours may fade over time. No other
warranty expressed or implied.