Poppers all done and the ragtop now fitted. I did not do a video for th e locking nuts fro the inside but a tip is to shut it completely and mark where the front bar sits in the rail. Do the same with it open. Then remove the front front bar and hold it up on the inside to the marks on the rails. This will enable you to make accurate holes for the locking screws. Thats it job done.
Disclaimer: For recreational purposes only, some assembly required. Any resemblance
to real persons,
living or dead is purely intentional and the site admins are not responsible
for direct, indirect,
incidental or consequential ridicule resulting from any defect or failure to
perform. No animals
were harmed in the creation of this forum. Colours may fade over time. No other
warranty expressed or implied.