the video gives you a tutorial how to dismount and mount the drive axle of a Passat 35i. Further the replacement of the boot on the outer CV joint is explained in detail:
The video has a German soundtrack, but English subtitles are available on YouTube.
Swing Axle Tubes fitted with OEM Axel boots Price: £150
A pair of Swing Axle Tubes in remarkably good condition. Have been dry stored for 15 years. Fitted with brand new OEM axle boots - ready to go.
Can drop off anywhere in London.
Limebug is just introducing our new full range of aircooled beams, all available online now at:
Stock 2" 4" Narrowed Beams for
All Versions of:
Split Screen (excluding Barndoor Currently)
I am overhauling back drum brakes, and fixing a leaky axel /hub
i was just about to put the wheel hub carrier thing back on,
when i took off the old small O ring, i noticed play (about 5mm ) where the axle can pull out. video below
is this a problem??
Hi I am after a beam in good nick for my 68 beetle due to it failing an mot as there is rot at both ends of the one currently fitted. Not fussed if its narrowed or standard width but adjustable would be good but again not essential - just need a beam!! Will even consider the full assembly if...
I'm at the point of rebuild that I really need to make my mind up about upgrading running gear on my 65 Panelvan!! :/
I'd really like air-ride... anyone got any suggestions of a good manufacturer or a self build genius please??
My beetle has been in storage for a bit, He had a leaky box (amongst a few other things), so I had My cousin Change the shoes, replace the rear wheel bearings and replace the seals from gearbox out on both sides. He was supposed to change the axle retainers aswell but he didnt...
As the title says....
Does anyone on here have a definitive set of measurements for the width of a Beetle's rear end? What I need is the width measurement in mm drum to drum (i.e. the wheel mounting surfaces) at its maximum for a:
mid 50s oval SA chassis
late 60s or early 70 SA chassis...
Was wondering if anyone had any ideas about the problem I have with my lower torsion arms. I removed all the arm to have new balljoint pressed into them. When fitting them back in the drivers side lower arm has a gap where as the others fit all nice and tight.
Anyone got any ideas as...
call me a tool but ive just got some of said bushes, which go where, i understand the replace the needle bearings. there are 2 long ones with rims, 2 shorter ones with rims and 2 short ones without rims. which go where.
Hi all, i'm thinking of doing a short axle conversion on my 1967 (four stud) Ghia as i want to fit my Porsche Fuchs replicas.
Background first -
I tried to fit some (four stud) gas burner replicas as an interim measure and the back ones would not get under the arches by a mile. Maybe the four...