Search Results for ‘carb setup’

I need to decide on what carb/s to use on my 1500 single port im putting together to run while I rebuild my 1641... I have a few options, I have a set of weber 34ict's that the 1641 is currently running with, so could use those if I can find single port manifolds for them Or I could steal the...

Right here we go again! This engine is starting to really wind me up now! I rebuild my engine, and have got it back in the car. I have set the valve clearances, set the points, static timed it and everything is on as it should be. I have also set the carb to the factory setting, and had it to...

I am going to replace my 009 with a vac advance dizzy due to the typical poor running problems with the 34 pict 3 and an 009. Question is, which vac port due I connect the vac pipe to? My carb has not got one in the usual place but has what looks like 2 others, one on each side of the carb, and...

Hi, Since wiring in my choke so it actually turns off:p and doing the timing, my engine splutters when putting my foot down hard, it isn't carburettor icing, i think it is related to timing, i don't know if it is too advanced or over retarded, can someone help??? :D cheers

Hi Where should the mixture and throttle stops be for first start on my DRLAs? Also is the theory of tuning the same as single choke carbs? E.g. screw in until stumbles then back out 1/2 turn? Just have to do it 4 times instead of 2? Cheers :) I know this will have been asked loads but can't...