I'm having a garage clearout
As you will see from the pictures, there are exhausts, a carb, a couple of manifolds, couple of bits of tinware (very solid) and a couple of rocker covers . And the steam boat trunk
There are 10 exhausts (mostly single hotspot) at least 7 of which are...
As per title, I have a 1600cc TP Long block for sale.
no end float.
Came out of my 71 bay after I upgraded to a 1776
Looking for £350.00 ono
I have a set of 1641 barrels and pistons. £85.00 ono
dog house fan shroud £20
Empi 34 pict 3 carb, ran perfectly on this engine £60
I can try and...
Here is a link to what my engine is doing
I have a 34 pict 3 carb on there with a svda distributor at the moment, I'm struggling to adjust the idling out, Currently the rpm seems to be pulsing. I've rebuilt the carb, checked the choke and fuel squirt.
Ive ensured my valves are correct as...
Hi... I am having a nightmare sourcing anyone who can help rebuild my solex 34 pict 4 carb for my T25 1.6 CT engine. Even a gasket and jet kit seem impossible to get hold of. Has anybody had this experience know who may stock refurbished ones or overhaul, supply parts?? Or any ideas of a...
Right, got a couple of type 1 bits for sale.
1/ 30amp dynamo, with fan and backing plate, plus the regulator as well. Been stored is shed for last ten years, painted green for some reason. £30 the lot, plus postage.
2/ 1300 tp carb manifold with heat riser tubes, painted green. £15 plus...
I have recently purchased my very first beetle (worked on a buggy previously) My beetle is a twin port 1300.
The engine was rebuilt before i purchased it, iv not driven it yet, it was sitting garaged for 9 nine years and this weekend with the help of friends stripped and cleaned the...
Just starting to clean the engine in my new beetle,
I believe it to be a 1200 single port. As I don't think they made 1200 dual port.
The carb is a solex 30PICT3
Is this correct for my model, thanks
Evening all, more goodies for ya! Everything is sold as per the pics below. I'm always open to offers and any questions - just let me know!
Original excellent condition interior front door panels - slight wear in the usual places £55 per pair (inc P & P)
X 2 Rare Original Oval Light Switch...
So my crankcase is now on the way out with extremely excessive end float, leaks in various places, and bodged oversize head studs, its ugly. I'm debating which route I should take with currently about £1000 to spend, but I can borrow a small amount. Here are my options:
Keep my 1600 barrels &...
Got a new weber 32/36 carb on my beetle but having problems with cold starts due to the choke. I was wondering how to set up the choke and how it should be adjusted as runs well when hot just doesn't start up without the accelerator to the floor. Any advice would be great cheers liam
Type 1 engine...
Has anyone else had the carb nuts come loose? The ones that secure the carb to the manifold?
We were doing a fairly long drive when the bus started overheating and wouldn't hold an idle.
I fiddled around in the engine bay for a bit before I realized that the carb was...
I have recently purchased a T25 1983 1900 DF watercooled engine. , It requires a new or replacement carb.
If anyone has or knows where I can buy a SOLEX 34 PICT 5 please let me know.
Or has anyone replaced this carb with another. Let me know.
Hi folks... I'm new to volkszone, and new to aircooled with a 72 beetle... It runs ok but has lack of pull at low rpm... So I wanted to change the ignition over to electronic to see if it helps. My carb is a solex 34 pict 3 and I'm trying to figure out if I can use a distributor that has a...
I have an early bay with 1600 SP, doghouse oil cooler.
I have had to replace my carb with a friends spare, and was just trying to adjust the Volume Control Screw as per Haynes manual, but it does not appear to make any difference, whether it is screwed right in, or right out.