Volkszone Forum banner

1 - 3 of 3 Posts

·
Watercooled, and warm!
Joined
·
10,277 Posts
Discussion Starter · #1 ·
Ok so the bus is in bits and awaiting paint, I've managed to get a loan of a mates mig welder, I used to do industrial mig welding/fabrication, so I'm not a novice just a little rusty. I need to replace the drivers side cab floor and the passenger front step/arch.

The cab floor looks straight forward enough, exept how to you get round(ha ha) the peadels?

And with the frtont arch where to you unpick the old one from?
 

·
Banned
Joined
·
18,444 Posts
BarryWinsper said:
Ok so the bus is in bits and awaiting paint, I've managed to get a loan of a mates mig welder, I used to do industrial mig welding/fabrication, so I'm not a novice just a little rusty. I need to replace the drivers side cab floor and the passenger front step/arch.

The cab floor looks straight forward enough, exept how to you get round(ha ha) the peadels?

And with the frtont arch where to you unpick the old one from?
Hard to talk you throug it but mesur mesur and mesur again

Here is mine



then finished

 
1 - 3 of 3 Posts
Top