Volkszone Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
231 Posts
Discussion Starter · #1 ·
Need to change my rusty old rear (lower) corners on my 73' bay. I will be using an angle grinder, any tips do's and dont's?? and what sort of disc is best? Also tips on welding new ones back in??
muchas gracias!!
:D
 

·
Registered
Joined
·
1,153 Posts
measure then measure it again , see if you can get a joddler , it puts a step in the panel so that they sit flush , overlaping looks a mess and its very hard to get them butted
 
1 - 2 of 2 Posts
Top