Volkszone Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2,766 Posts
Discussion Starter · #1 ·
I'm havin a few running problems so trying different things to solve it. The carb fitted is a Bocar 34PITC3 ! From what I've read these are pants anyway.
I took the carb off last night give it a good clean inside and blew out with the air line.
Now I've come to set it up again and there are two screws on the side,
1. Small - Idle mixture screw
2. Big - By pass air screw
The manual is telling me what to adjust but the big screw (bypass air screw) Will not turn !!! Should it be free ?
I've got a Solex on the way next week for rebuild but i need to get the van moving. Also I've never messed with carbs before so its all pretty new to me.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top