Volkszone Forum banner

how tight hubnut?

510 Views 2 Replies 3 Participants Last post by  purplepete
good morning i was just wanting to know how tight the rear hubnut should be on a 67 beetle? its on my 66 splitty which i have just straight axled and so the runnig gear is now 67 beetle! any advise would be much appreciated! :hangloose
1 - 3 of 3 Posts

basically as tight as you can get it with a 6ft bar until the split pin holes line up.
Do it properly!!get a pair of bathroom scales!!
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.