Volkszone Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,752 Posts
I didnt cut mine to take Dell 45`s, i remember they were a little bit of a squeeze the first time they went on, but i used a thin bladed screwdriver to ease them past the edge of the tin and that was enough to bend the lip of the tin very slightly to allow them to pass and it was just a very slight bend.
 

·
Registered
Joined
·
623 Posts
I used a set of pliers and slowly went around the inside edge bending it back to make the hole a bit bigger.
 
1 - 5 of 5 Posts
Top