Volkszone Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
116 Posts
Discussion Starter · #1 ·
Hi all, I'm going to rebuild the carbs on my Type 3 Square tomorrow.
I've brought a rebuild kit from T3D and have read up on it but it says that I need a special tool to balance the carbs...where can I get one of these or can I make one??

Has anyone got a guide that may make my life easier or any advice??

Thanks

Jay
 

·
Registered
Joined
·
9,281 Posts
a local old skool parts place normaly stock guson ones, well theres one in my local shop, its a weird cone thing with a ball at the top which i think gets sucked in when its idling, and you get the twin carbs to suck this ball in the sam ammount,

have you tried halfords?? doubt they have one like,

you can get ones which are far more accurate, but cost a fair bit more like!
 

·
Registered
Joined
·
116 Posts
Discussion Starter · #4 ·
£14.99 from Halfords!!
And you don't have to pay an extra £12.50 for an adaptor :rolleyes:
 
1 - 5 of 5 Posts
Top