Volkszone Forum banner
1 - 2 of 2 Posts

· Registered
9,657 Posts
Best thing you can do is get a haynes manual for starters as it will indicate what cables are what.

Then if I was starting from scratch I would plug the loom into the engine and trace out any wires that are not connected to anything and see if they go back to the ECU.

with Digifant I am pretty sure its like 1 positive wire and a couple for the engine.

I did find this online if it helps:

at some stage I need to decode one of these looms too, just at present I am working through a modern 1.4tdi one for my bus!
1 - 2 of 2 Posts