Volkszone Forum banner
1 - 3 of 3 Posts

915 Posts
Discussion Starter · #1 ·

I have a late bay camper.
The main large tinware piece (sits infront of crank pulley and goes to the edge of the engine bay, with the high shoulder on the left..u know...lol) on mine is in a sorry state.
It has no holes but looks like its had a few repairs here and there with tape/fibre glass (not sure)....

2 questions really...

1) why is it near on impossible to get this part????

2) can this tinware be repaired by welding patches like you would normal bodywork? (using MIG on mild steel) or is it different material thats more heat resistant etc etc?

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.